12
OPERATION OF WIRELESS REMOTE CONTROLLER
MODE BUTTON
Use the “MODE” button to select one of the available modes.
The selected mode will be displayed on the remote controller
and the appropriate light will illuminate on the display panel.
AUTO – Unit will automatically select heating or cooling to
maintain room temperature between 68°F and 77°F.
The remote controller will display the Auto Mode icon with
no setpoint. The front panel display will show "77."
COOL – To cool to selected setpoint and remove moisture.
System varies compressor speed to maintain desired temperature.
HEAT – To heat to selected room setpoint. System varies compressor speed to maintain
desired room temperature.
FAN ONLY – To circulate air without heating or cooling. Use Fan Speed button to select
speed from low to high.
DRY – Select DRY MODE to increase moisture removal during warm humid conditions.
1. Room Temperature > Setpoint +4°F, the system will be operating in cooling
mode with low fan speed.
2. Setpoint -4°F, < Room Temperature < Setpoint +4°F, the system will cycle
6 minutes ON and 4 minutes OFF in cooling mode. The indoor fan will be at
low speed.
3. Room Temperature < Setpoint -4°F, the system will be OFF and the indoor fan
will be at low speed.
: AUTO
: COOL
: DRY
:
FAN ONLY
: HEAT
Icons Displayed
To Next Page
Loading...
