Service Manual
(4) Link(This function is APPlicable to some models)
Select a m aster device. W hen the environm ent satisfies the parameters as set in the master device, slave devices will execute
commands to realize devices linkage.
Step l ^ e t the parameters of master device (Select master device, select environment parameters, select master device status).
Tap n at the top right corner of the homepage "Device". Select "Link" and enter the page "Add linkage". Tap "Device/Param" to
enter the page "Select device". Take "baby room" as an example. Tap "babyroom".
Enter the page "Select environment parameters".
When babyroom
°CTemp
/>Mode
(Don/off
Tap "Temperature" to enter the page "Select temperature parameter". Slide up or down to adjust temperature. Tap "Upper limit" or
"Lower limit".
Tap "Mode" and "On/Off" to select the status of master device. Then tap "Save".
Step 2: Set time parameter for linkage. Tap "Time parameter" to enter the page "Set time". Slide
setting time.
rightwards to turn on the
Tap "Execution time"; then tap "Start" and "Stop" to set start time and stop time respectively. Tap "OK" at the top right corner to save the
setting.
28
• •
Installation and Maintenance
To Next Page
Loading...
