Service Manual
NOTE: After configuration is completed, the air conditioner hot spot connected to your phone will disappear. You should reconnect your
phone to the home WiFi router to realize long-distance control.The above configuration only needs onephone. Other types of phones
shall install this APP, connect with the air conditioner hot spot or wireless router of WiFi air conditioner. When connection is done, open
the APP to use short-distance operation to control the air conditioner and then you can use the long-distance control.
3.Configuration method for Apple phones
Step 1: Turn on Wi-Fi “Settings” on the phone.
No SIM ^ 12:32 PM
^ Settings Wi-Fi
Wi-Fi
C D
v' Tenda_36EA10
a
v
CD
CHOOSE A NETWORK...
12345678
a
CD
a0b41737
a ¥
CD
a0b41740
a
9
CD
greejy
» ®
HUAWEI-HXTENV
a ^
CD
HUAWEI-HXTENV_5G
« ^
CD
sss_5G
b
■=?
(D
Step 2: In general, the hot spot signal of air conditioner is the last 8 bits of MAC address. Eg: Select "a0b41737” and enter
the defaulted password "12345678” to connect it.
No SIM =? 12:32 PM
Enter the password for "a0b41737"
Cancel Enter Password Join
1234567890
»« .,?!' <H)
Step 3: Turn on APP, press "+” button, press "Add device” to enter into the page of "Add device” and then select "Manual configuration” .
Enter wireless router’s SSID and PSW on the page of "Manual configuration”. The display on the server will be the same as the selection
when registering the account ( server selection in "Setting”).
Eg: WiFi name: Tenda_XXX;
WiFi password:123456789
Server: Europe
Check whether the filled inform ation is correct. If the inform ation is wrong, configuration will fail. Press "Configuration” to start
configuration.
Notice:
Finally, press "Configuration”, and APP will send the filled information to Wifi Smart. At this time, the buzzer will give out a sound, which
indicates it has started to connect the wireless router.
Installation and Maintenance 0
35
To Next Page
Loading...
