Service Manual
7. C onnect W ire o f In doo r Unit
(1) Open the panel, remove the screw on the wiring cover and
then take down the cover.(As show in Fig.11)
Fig.11
(2) Make the power connection wire go through the cable-cross
hole at the back of indoor unit and then pull it out from the front
side.(As show in Fig.12)
Fig.12
(3) Remove the wire clip; connect the power connection wire
and signal control wire to the wiring terminal according to the
color; tighten the screw and then fix them with wire clip.(As
show in Fig.13)
N(1)
2 3
©
Fig.13
Note: the wiring connect is for reference only,
please refer to the actual one.
(4) Put wiring cover back and then tighten the screw.
(5) Close the panel.
A Note:
(1) All w ire s o f in d o or u nit and o u td o or u n it sho uld be
connected by a professional.
(2) If the length of power connection wire is insufficient, please
contact the supplier for a new one. Avoid extending the wire by
yourself.
(3) For the a ir co nd itio n er w ith plug, the plug should be
reachable after finishing installation.
(4) For the air conditioner without plug, an air switch must be
installed in the line. The air switch should be all-pole parting
and the contact parting distance should be more than 3mm.
8. Bind up Pipe
(1) Bind up the connection pipe, power cord and drain hose
with the band.(As show in Fig.14)
(2) Reserve a certain length of drain hose and power cord
for installation when binding them. When binding to a certain
degree, separate the indoor power and then separate the drain
hose.(As show in Fig.15)
(3) Bind them evenly.
(4) The liquid pipe and gas pipe should be bound separately at
the end.
Fig.14
Connection pipe Drain h°se Band
Fig.15
A Note:
(1) The power cord and control w ire ca n't be crossed or
winding.
(2) The drain hose should be bound at the bottom.
9. Hang the Ind oor Unit
(1) Put the bound pipes in the wall pipe and then make them
pass through the wall hole.
(2) Hang the indoor unit on the wall-mounting frame.
(3) Stuff the gap between pipes and wall hole with sealing gum.
(4) Fix the wall pipe.(As show in Fig.16)
(5) Check if the indoor unit is installed firmly and closed to the
wall.(As show in Fig.17)
Indoor-
Outdoor
Fig.17
A Note:
Do not bend the drain hose too excessively in order to prevent
blocking.
Installation and Maintenance %
59
To Next Page
Loading...
