GREE Air-ccoled Closed Control Unit Service Manual
73
● Start Communicating: Click Main Menu->Control->Link an equipments and the system can
communicate with the unit. In this case, you can check the data of units.
4.2.8 Control Unit
● Left click any Device in Module(1), select "The machine set control" in popup menu after right
click
，as following picture shows:
After setting the parameter in control interface, click "OK" to start operation as the figure
below. No.1
、No.2、No.3、No.4 in following red frame refer to Device(1)、Device(2), Device(3)、
To Next Page
Loading...