Receiver JS13
2
2 Notices for Application
☆
The power supply mode of each indoor unit must be unified power supply.
☆
Never install the Receiver in a humid place or a place with direct sunlight.
☆
Prevent knocking, throwing, frequent disassembly and assembly of the Receiver.
☆
Do not operate the wired controller with wet hands.
☆
This product is applicable for multi VRF central air conditioners.
☆
Pay attention to the following when matching with multiple VRF units:
① When the priority of system mode is master-slave mode, one indoor unit
must be set as master-mode indoor unit (master indoor unit) in a system
network, and the other indoor units are slave indoor units.
② When the priority of system mode is master-slave mode, the system mode
is subject to the operation mode of the master indoor unit. The master indoor
unit can be set to any mode (including automatic mode), and the slave indoor
unit cannot be set to the mode that conflicts with the system mode. When
the master indoor unit changes mode and cause a conflict between the
operation mode of the slave indoor unit and the system operation mode, the
operation mode of the slave indoor unit will automatically changes to the
system operation mode.
③ The system mode priority is cooling priority, heating priority, first opening
priority, second opening priority. The indoor unit can be set to any mode
(excluding automatic mode). When the indoor unit operation mode is in
To Next Page
Loading...
General