Gree KF-70DW/NA1 - Heat Mode Operation

16 ~ 30
4.
5.
1.
2.
3.
REMOTE CONTROL OPERATION PROCEDURE
TIMER ON TIMER OFF ANION SAVE
7.11
21
HEAT mode operation
When room sensor detected temp. is lower than setting temp., heat mode start running.
When room sensor detected temp. is higher than setting temp., indoor fan motor stop
running, water valve is turned off, heat operation is stopped.
The setting range is
Press SWING button, the
louver guide will automatically
swing, when repressed it, once
more, it will stop swinging.
Press FAN button to set
fan speed.
Press the temp. set the
desired temp.
After powered on, press 1/0
button, air conditioner is running.
mode.
Press mode button, select
When cooling only unit receives heat mode
signal, it will run at fan mode.