7.12
16
~
30
3.
4.
2.
１．
REMOTE CONTROL OPERATION PROCEDURE
22
DRY mode operation
Press SWING button,
it will swing automatically.
Press the button to ad-
just the suitable tempera-
ture.
When pluged in, press
1/0 button, the unit will
run.
Press MODE button,to
has been selected, the fan
speed is unavailable.
select the (if the
When room sensor detected the temp. is lower than setting temp. 2℃ or more, the
water valve, indoor fan motor stop running.
When room sensor detected the temp. is between the ± 2℃ of the setting temp.
it will enter into dry mode operation, when room sensor detected the temp. is higher
than the setting temp.2℃ or more, it will enter into cool mode operation. The indoor
fan motor runs at low fan speed.
In this mode, the setting temp. range is
To Next Page
Loading...
