79
1.
2.
After putting through the power, press "ON/OFF" button on remote controller to turn on the air conditioner.
3.
4.
Press "▲" or "
▲
" button to set your required temperature. (Temperature cant be adjusted under auto mode).
Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN, HEAT.
Press "SWING" button to select fan blowing angle.5.
Press "FAN" button to set your required fan speed: auto, low, medium and high speed.
Replacement of batteries in remote controller
●
During operation, point the remote control signal sender at the receiving window on indoor unit.
The distance between signal sender and receiving window should be no more than 8m, and there should be no obstacles between them
indoor unit during operation.
Replace new batteries of the same model when replacement is required.
When you dont use remote controller for a long time, please take out the batteries.
1.
If the display on remote controller is fuzzy or theres no display, please replace batteries.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the position of "+" polar and "-" polar
are correct.
3. Reinstall the cover of battery box.
Press the back side of remote controller marked with "
out
the cover of battery box along the arrow direction.
Note:
signal sender battery
Cover of battery box
remove
reinstall
To Next Page
Loading...
