19
A Series Inverter Modular Air-cooled Chiller (Heat Pump)
■ Drainage
(1) Loosen screws around the panel and then take down it.
(2) Remove anticlockwise the blind plug located at the bottom of the heat exchanger to let the chilled
water ow out, after that, tighten the blind plug and reinstall the panel. (Note: place the drainage
equipment beneath the drain pipe to prevent pollution caused by the drain water.
Drain valve
NOTE
Keep the purge valve of the water system open in order to drain the evaporator and condenser
completely.
5 Introduction to the display panel
See the Operation Instructions for the display panel of the inverter modular type chillers for
more details.
NOTE
The control display should be placed in the position where the temperature is above -20°C
.
6 Electric wiring
6.1 External wiring of the electric control cabinet
(1) LSQWRF35VM/NhA-M
To Next Page
Loading...
