S2S KNX Gateway
8
Fig.4.2 Wire connection for wired controller
Connect to KNX system:
Use standard EIB bus bar to connect the KNX+ (red) of S2S KNX Gateway
to the KNX system bus bar KNX+, and connect the KNX- (black) to the KNX
system bus bar KNX-, there is requirement for polarity.
Requirement of communication wire material:
Material and length of communication wire should be selected according to
KNX standard strictly.
Installation:
Adopt standard 35mm guide rail installation method, as shown as below:
To Next Page
Loading...
