S2S KNX Gateway
13
Parameter “Lower limit Temp. of Dehumidify energy saving[16..30]
℃
”
This parameter is to set the lower limit temperature of energy-saving
dehumidify.
Parameter “Scene”
This parameter is to set if activate the scene function. After activating this
function, the “Scene” parameter setting card will appear, as shown in Fig. 6.2.
6.2 Setting Interface of “Scene” Parameter
Setting interface of “Scene” parameter is shown as Fig.6.2. Here can set
the function of each scene. There are a total 4 scenes, the settable options of
each scene are the same:
To Next Page
Loading...
