Gree ME30-24/F1 K

S2S KNX Gateway
15
“activate” function in the ETS software can transfer the scene, and use the “learn”
function in the ETS software can save the setting. The value to be saved is the
current status of air conditioner, the other three scenes also can adopt such
method.
Parameter “ON/OFF”:
This parameter is to set the ON/OFF of the first scene, the other three
scenes are in the same rule.
Parameter “Tempearture [16..30]
℃
”:
This parameter is to set the setting temperature of the rst scene, the other
three scenes are in the same rule.
Parameter “Mode”:
This parameter is to set the mode of the rst scene, the other three scenes
are in the same rule.
Parameter “Fan Speed”:
This parameter is to set the fan speed of the rst scene, the other three
scenes are in the same rule.
6.3 Setting Interface of “Status” Parameter
Setting interface of “Status” parameter is shown as Fig.6.3. Here can set
the ON/OFF, fan speed, mode, set temperature, outdoor temperature, indoor
temperature, mode of sending status of error code: