S2S KNX Gateway
2
(8) Please do install the appliance inside the inapproachable and locked
electric control cabinet indoors.
(9) Please install this appliance in the place where is without interference of
electromagnetic wave or dust.
Caution!
(1)It is not allowed to install the equipment in wet place or under direct
sunlight.
(2) Please make sure that the equipment is installed in the correct position,
otherwise it may cause communication error.
(3) Make sure that the communication wire is connected into the correct
interface, otherwise it may cause communication error.
(4) After connecting the wires, please use insulated adhesive tape to protect
the wire to prevent oxidation or short circuit.
(5) Requirement for normal working environment of S2S KNX Gateway:
①
Temperature: 0
℃
~ +45
℃
;
②
Humidity: less than 85%, except for the condensation of dew;
③
It should be installed inside the electric control cabinet and prevent direct
sunlight, rain, snow, etc.
(6) All the illustrations in the instruction manual are only for reference.
To Next Page
Loading...
