READ ALL INSTRUCTIONS BEFORE INSTALLATION OR USE
SAFETY CONSIDERATIONS
Recognize safety information, This is the safety-alert
symbol/K When you see this symbo! on the unit and
in instructions or manuals, be alert to the potential for
personal injury,
Understand these signal words: DANGER,
WARNING, and CAUTION, These words are used
with the safety-alert symbo!, DANGER identifies the
most serious hazards which will result in severe
personal injury or death, WARNING signifies hazards
which could result in personal injury or death,
CAUTION is used to identify unsafe practices which
may result in minor personal injury or product and
property damage, NOTE is used to highlight
suggestions which will result in enhanced
insta!lation, reliability, or operation,
PERSONAL INJURY AND/OR PROPERTY DAMAGE
HAZARD
Failure to follow this warning could result in personal il\jury,
death and/or property damage.
For your safety, the information in this manual must be
followed to minimize the risk of fire or explosion, electric
shock, or to prevent property damage, personal il\jury, or loss
of life.
* This unit must be properly installed in accordance
with the Installation Instructions before it is used.
* Immediately repair or replace all electric service
cords that have become frayed or otherwise
damaged.
* Unplug or disconnect the unit at the fuse box or
circuit breaker before making any repairs.
GENERAL
Thank you for choosing the Gree PTAC! You can
fee! confident in your selection because of the pride
in craftsmanship and engineering knowledge that
goes into this equipmentt.
Gree package terminal air conditioners and heat
pumps provide a high standard of quality in
performance, workmanship, durability and
appearance as they heat and coo! the occupied air
space year round.
This manua! provides information for ease of
installation, operation and maintenance.
All models are designed for through-the-wall
installation. Separate installation instructions are
included with all accessory components.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT: Save these instructions for local
inspector's use.
IMPORTANT: Observe all governing codes and
ordinances.
NOTE TO INSTALLER
Be sure to leave these instructions with the owner.
NOTE TO OWNER
Keep these instructions for future reference. Be sure
to write down the mode! and serial number of unit on
space provided on front page. The mode! and serial
number can be located on the serial number plate
attached to unit.
NOTE: We strongly recommend that any servicing
be performed by a qualified individua!.
Save the wall thermostat contro! panel labe! to be
placed on control panel in case a wall thermostat is
used or is added in the future. (See Fig. 23)
To Next Page
Loading...
