Gree PULAR Series

31
Technical Information
Service Manual
6. Function and Control
6.1 Remote Controller Introduction
Introduction for icons on display screen
TURBO
FAN
MODE
ON/OFF
I FEEL
T-ON T-OFF
TEMP CLOCK
LIGHT WiFi SLEEP
Set temperature
WiFi function
Sleep mode
8
heating function
Health mode
Scavenging function
Quiet
X-FAN function
Set temp.
temp.
Outdoor ambient
temp.
Indoor ambient
Clock
Operation mode
Set time
Turbo mode
Send signal
Auto mode
Cool mode
TIMER ON / TIMER OFF
Left & right swing
Up & down swing
Child lock
Dry mode
Fan mode
Heat mode
Temp.
I feel
Set fan speed
display type
●
Notice
:
doesn't have, if press the corresponding button on the remote controlle
r, the unit will keep the original running status.
●
This is a general use remote controller. It could be used for the air conditioner with multifunction. For the functions which the model
the air conditioner by using remote controlle
r.
●
After putting through the power, the air conditioner will give out a sound. Operation indicator "" is ON. After that, you can operate
and the air conditioner will give out a "di" sound, which means the signal has been sent to the air conditioner
.
Under on status, pressing the button on the remote controller, the signal icon " " on the display of remote controller will blink once
MODE
Press this button to select your required operation mode.
ON/OFF
MODE
Press this button to turn on the unit. Press this button
again
to turn off the unit.
When selecting auto mode, air conditioner will operate●
AUTO COOLDRY FAN HEAT
●After selecting cool mode, air conditioner will operate under
automatically according to ex-factory setting. Press "FAN"
button can adjust fan speed. Press "" / " " button ca
n
adjust fan blowing angle.
● When selecting dry mode, the air conditioner operates
cool mode. Cool indicator " " on indoor unit is ON.
(This
indicator is not available for some models.) Press "▲" or
" ▼ "button to adjust set temperature. Press "FAN" button
to adjust fan speed. Press " " / " " button to adjust
fan
blowing angle.
●When selecting fan mode, the air conditioner will only blow
at low speed under dry mode. Dry indicator " " on indoor
unit is ON. (This indicator is not available for some models.)
Under dry mode, fan speed can’t be adjusted. Press " " /
" "button to adjust fan blowing angle.
When selecting heating mode, the air conditioner operates●
fan, no cooling and no heating. All indicators are OFF.
Press
"FAN" button to adjust fan speed. Press " " / " " button to
adjust fan blowing angle.
●For preventing cold air, after starting up heat mode, indoor
unit will delay 1~5 minutes to blow air (actual delay time
depends on indoor ambient temperature).
under heat mode. Heat indicator " " on indoor unit is
ON.
(This indicator is not available for some models.) Press
"▲"
or " ▼ " button to adjust set temperature. Press "FAN" button
to adjust fan speed. Press " " / " " button to adjust
fan
blowing angle. (Cooling only unit won’t receive heating mode
signal. If setting heat mode with remote controller, press ON/
OFF button can’t start up the unit).
Notice: