Greenlee 555SB - User Manual

Need help?

Do you have a question about the Greenlee 555SB and is the answer not in the manual?

Summary

Greenlee 555 SB Speed Bender Manual

Important Safety Instructions

General Safety Precautions

555 SBC Bending Operations

Bending Set-Up and Zeroing

Bending Loading and Process

Instructions for loading conduit and performing the bending process.

Using Bend Memory

Steps for using the bend angle memory function.

555 SBC Bending Data and Offsets

Locating Bending Marks

Guide to finding and marking conduit for bends.

Calculating Offset Bends

Procedure for calculating and marking conduit for offset bends.

555 SBR Bending Operations

555 SBR Set-Up, Loading, and Zeroing

555 SBR Bending Process

Instructions for performing the bending process on the 555SBR.

555 SBR Bending Data and Offsets

Locating Bending Marks for 555 SBR

Guide to finding and marking conduit for 555SBR bends.

Calculating 555 SBR Offset Bends

Adjustment Procedures

Roller Support Squeeze Adjustment

Service and Maintenance

Gearbox and Chain Maintenance

Electrical Systems and Troubleshooting

Major Electrical Components

Electrical Troubleshooting Guide

Diagnosing and resolving electrical issues with the bender.

Component Removal and Replacement

Circuit Board Procedures

Sensor and Bend Angle Control Procedures