Greenlee ESC85 - Product Description; Product Details; Manual Purpose; Manual Scope

ESC85 Battery-powered Cable Cutter
Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
2
Description
The ESC85 Battery-powered Cable Cutter is a hand-
held tool intended to cut copper and aluminum cable
up to 85 mm (3-1/4") in diameter. This tool is intended
to cut most low- and medium-voltage stranded copper
and aluminum cable found on most job sites.
Safety
Safety is essential in the use and maintenance of
Greenlee tools and equipment. This manual and any
markings on the tool provide information for avoiding
hazards and unsafe practices related to the use of this
tool. Observe all of the safety information provided.
Purpose of this Manual
This manual is intended to familiarize all personnel with
the safe operation and maintenance procedures for the
following Greenlee tool:
ESC85 Battery-powered Cable Cutter
Keep this manual available to all personnel.
Replacement manuals are available upon request at
no charge.
All specications are nominal and may change as design
improvements occur. Greenlee Textron Inc. shall not be liable for
damages resulting from misapplication or misuse of its products.
GATOR is a trademark of Greenlee Textron Inc.
AVIA is a registered trademark of Avia International.
Mobil is a registered trademark of Mobil Oil Corporation.
NUTO is a registered trademark of Exxon Corporation.
Tellus is a registered trademark of Shell Oil Company.
Molykote is a registered trademark of Dow Corning Corporation.
KEEP THIS MANUAL
Table of Contents
Description .................................................................... 2
Safety ............................................................................ 2
Purpose of this Manual ................................................. 2
Important Safety Information .....................................3–4
Identication .................................................................. 5
Specications ................................................................ 5
Operation ....................................................................... 6
Maintenance .................................................................. 7
Troubleshooting ............................................................. 8
Disassembly .................................................................. 9
Assembly ..................................................................... 10
Illustrations .............................................................11–13
Parts List ................................................................14–16