Why does the actual cutting height not match the setting on my GreenWorks Pro Lawn Mower?
If the actual cutting height of your GreenWorks Pro Lawn Mower doesn't match the setting, check the bolts fixing the deck, and adjust them to ensure the deck is installed firmly. Also, the deck may be severely worn or damaged, and you should replace it with a new one. Remember to level the deck again after adjusting the bolts.
What to do if my GreenWorks Pro RZ48 Lawn Mower cuts abnormally?
If your GreenWorks Pro Lawn Mower is cutting abnormally, it might be because the lawn is too wet. Check the grass condition and wait until it is dry before cutting. Alternatively, the grass cutting capacity might be set too high; raise the deck height, and try to avoid cutting heavy grass.
Why is my GreenWorks Pro RZ48 off track?
If your GreenWorks Pro Lawn Mower is off track, it could be due to different tire pressure in the left and right rear tires. Regularly check the rear tire pressure according to the manual.
What to do if my GreenWorks Pro Lawn Mower is blocked?
If your GreenWorks Pro Lawn Mower is blocked, it's likely that the deck is full of weeds and garbage. Clean the machine according to the manual after each use.
General| Cutting Width | 48 inches |
|---|---|
| Deck Material | Steel |
| Battery Type | Lithium-Ion |
| Motor | Brushless |
| Deck Size | 48 inches |
| Drive System | Electric |
| Drive Type | Electric |
| Cutting Options | Mulch, Side Discharge, Bagging |
To Next Page
