13
ATTACHING THE GUARD
(See
Figure 2.
)
NOTE: Install the guard before the attachment is connected to the lower shaft.
1. Remove supplied screw with a phillips screwdriver from the trimmer head.
2. Fit the guard into the slots on trimmer head.
3. Turn counterclockwise to lock grass deector into place.
4. Line up the screw hole in the grass deector with the center hole in the trimmer head.
5. Install supplied screw and tighten by turning clockwise with a phillips screwdriver.
ASSEMBLY
GRASS DEFLECTOR
SLIDE OVER HEAD
AND TURN COUNTER
CLOCKWISE
Fig. 2.1
SCREW HOLE
SCREW
Fig. 2.2
To Next Page