SAFETY INFORMATION
SAVE THESE INSTRUCTIONS
77
• Do not disassemble charger, take it to an authorised service station if repair is required.
Incorrect reassemble may result in a risk of electric shock or re.
• Unplug charger from outlet before attempting any cleaning to reduce the risk of electric shock.
• Disconnect charger from the power supply when not in use to prevent damage to the charger
during a power surge.
• Do not expose machine to rain or wet conditions. Water entering charger will increase the risk
of electric shock.
• Make sure cable is located so that it will not be stepped on, tripped over, come in contact with
sharp edges or moving parts or otherwise subjected to damage or stress. This will reduce the
risk of accidental wash, which could cause injury, and damage to the cable, which could result
in electric shock.
• Keep cable and charger away from heat to prevent damage to housing or internal parts.
• Do not let gasoline/petrol, oils, petroleum-based products, etc. come in contact with plastic
parts. They contain chemicals that can damage, weaken, or destroy plastic.
• An extension cable should not be used for the charger unless absolutely necessary. Use of
improper extension cable could result in a risk of re and electric shock. If extension cord
must be used, make sure:
• That pins on plug of extension cord are the same number, size and shape as those of plug
on charger.
• That extension cord is properly wired and in good electrical condition.
W A R N I N G
If any parts are missing, do not operate unit until the missing parts are replaced. Failure to do
so could result in possible serious personal injury.
W A R N I N G
When transporting or servicing unit, always remove the key and battery.
W A R N I N G ( P R O P O S I T I O N 6 5 )
Some dust created by power sanding, sawing, grinding, drilling and other construction activities
contains chemicals known to the state of California to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and other masonry products, and
• Arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To
reduce your exposure to these chemical: work in a well ventilated area, and work with approved
safety equipment, such as those dust masks that are specially designed to lter out microscopic
particles.
To Next Page
