6 TRANSPORTATION, STORAGE AND DISPOSAL
6.1 TRANSPORTATION
• Any removable (electronic) parts, such as the charger and battery, should always be disconnected before
transport.
• Avoid transporting the product in bad weather conditions.
• Make sure to adequately cover any exposed electronic parts if transportation in adverse weather conditions is
unavoidable.
• Use tape on open contacts of the battery and ensure it is securely stowed to prevent movement.
• High speeds, along with wind and rain, may force moisture into the electronic components, which can lead to
temporary malfunctions or permanent defects.
• In case of malfunction occurring after transport in such conditions, remove the battery and allow all parts to air-dry
when you reach your destination.
6.2 STORAGE
If the product is left unused for an extended period, proper storage maintenance is required.
• Store the product locked up to prevent unauthorized use or damage.
• Store the product in a dry, well-ventilated area.
• Store the product out of the reach of children.
6.3 DISPOSAL OF THE BATTERY, BATTERY CHARGER, AND PRODUCT
Symbols on the product or the package of the product mean that the product is not domestic waste. Recycle it at
a recycling station for electrical and electronic equipment. This helps to prevent damage to the environment and
persons.
Get in touch with your local authorities, domestic waste service, or your dealer for more information about how to
recycle your product.
7 TROUBLESHOOTING
PROBLEM POSSIBLE
CAUSE
POSSIBLE
SOLUTION
The product
does not start.
The battery is
not installed
tightly.
Make sure that
you securely in-
set the battery
in the product.
The battery is
out of power.
Charge the bat-
tery.
The switch is
defective.
Replace the de-
fective parts
through an au-
thorized service
center.
The motor is de-
fective.
The PCB board
is defective.
The air does
not flow
through the
tube when you
start the prod-
uct.
The air inlet or
tube outlet has a
blockage.
Carefully re-
move the block-
age.
8 TECHNICAL DATA
Voltage 80V DC
Air volume 800 CFM (0.38 m
3
/s)
Air speed 200 MPH (89.4 m/s)
Battery model BAB742, BAB741 and other BAB
series
Charger model GCH8020 and other CAB series
The recommended ambient temperature ranges:
Situation Temperature
Product storage 32 ˚F (0 ˚C) ~ 113 ˚F (45 ˚C)
Product operation 32 ˚F (0 ˚C) ~ 113 ˚F (45 ˚C)
Battery charging 39 ˚F (4 °C) ~ 104 ˚F (40 ˚C)
Charger operation 39 ˚F (4 °C) ~ 104 ˚F (40 ˚C)
Battery storage 32 ˚F (0 ˚C) ~ 113 ˚F (45 ˚C)
Battery discharging 32 °F (0 °C) ~ 113 °F (45 °C)
11
English
EN
To Next Page
Loading...
