GreenWorks MO13B00 - Installation; Unpack the Machine; Unfold and Adjust the Handle; Install the Grass Catcher

1. Pull up and back the upper handle (2) to lift the handle
into operation position. Make sure that the handles click
into position correctly.
2. Tighten the lower handle (4) with the konbs (12) on the
two sides.
3. Tighten the upper handle (2) with the cam locks (11) and
konbs (10) on the two sides.
NOTE
Make sure that the two handles are in the same position.
WARNING
Do not make damage to the cables when you fold or unfold
the handle.
7.3 INSTALL THE GRASS CATCHER
8
13
14
1. Remove the mulch plug.
2. Open the rear discharge door (13) and hold it.
3. Hold the the grass catcher (8) by its handle and engage
the hooks (14) on the door rod.
4. Close the rear discharge door.
7.4 INSTALL THE MULCH PLUG
13
6
1. Remove the grass catcher.
2. Open the rear discharge door (13) and hold it.
3. Hold the mulch plug (6) by its handle and fit it in the
discharge chute.
4. Close the rear discharge door.
7.5 INSTALL THE SIDE DISCHARGE
CHUTE
15
7
CAUTION
When you use the side discharge chute,
• Do not install the grass catcher.
• Keep the mulch plug installed.
1. Open the side discharge door (15) and hold it.
2. Line up the recesses of the side discharge chute (7) below
the pivot.
3. Close the side discharge door.
7.6 SET THE CUTTING HEIGHT
The machine can be set to different blade heights.
9
English
EN