What to do if my GreenWorks Lawn Mower handle is not in position?
If the handle of your GreenWorks Lawn Mower is not in position, it's likely that the bolts are not engaged correctly. Adjust the height of the handle and make sure that the knobs and bolts are aligned correctly.
What to do if my GreenWorks MO40B00 is hard to push?
If your GreenWorks Lawn Mower is hard to push, it could be because the grass is too tall, or the blade height is too low. Try increasing the blade height.
Why is there a high vibration in my GreenWorks Lawn Mower?
A high vibration in your GreenWorks Lawn Mower can occur if the blade is unbalanced and worn; in this case, replace the blade. It could also be that the motor shaft is bent. If so: 1. Stop the motor. 2. Remove the safety key and battery pack. 3. Disconnect the power source. 4. Inspect for damage. 5. Repair the machine before you start it again.
General| Motor | Brushless |
|---|---|
| Voltage | 40V |
| Cutting Width | 20 inches |
| Deck Material | Steel |
| Power Source | Battery |
| Battery Included | Yes |
| Charger Included | Yes |
| Type | Electric Lawn Mower |
| Battery Compatibility | GreenWorks 40V |
To Next Page