19
MAINTENANCE
NOTE: If chain is too tight, it will not rotate. Loosen the bar cover knob slightly and turn adjusting
screw 1/4 turn counterclockwise. Lift the tip of the bar up and retighten bar cover knob.
NOTE: Do not use dirty, used, or otherwise contaminated lubricants. Damage may occur to the oil
pump, bar, or chain.
CHAIN OILER
• Use a lubricant that is designed for chains and chain oilers and is formulated to perform
over a wide temperature range with no dilution required.
• Remove the cap and carefully pour approximately 2 oz (57 g) of bar and chain lubricant into
the bar lube reservoir.
• Replace the cap and tighten securely.
• Check and rell the bar lube reservoir every time the polesaw is used.
Oil tank cap
To Next Page
Loading...
