GreenWorks STF 305 - Page 4

1 Description......................................... 2
1.1 Purpose.............................................................. 2
1.2 Overview........................................................... 2
2 Introduction....................................... 2
3 General power tool safety
warnings............................................. 2
3.1 Training..............................................................2
3.2 Preparation.........................................................2
3.3 Operation........................................................... 3
3.4 Maintenance.......................................................3
3.5 Service............................................................... 4
4 Symbols on the product.................... 4
5 Risk levels...........................................4
6 Recycle................................................4
7 Installation......................................... 5
7.1 Unpack the machine.......................................... 5
7.2 Attach the guard.................................................5
7.3 Assemble the shaft.............................................5
7.4 Attach the auxiliary handle................................5
7.5 Install the battery pack.......................................5
7.6 Remove the battery pack................................... 5
8 Operation........................................... 5
8.1 Controls............................................................. 6
8.2 Start the machine............................................... 6
8.3 Stop the machine............................................... 6
8.4 Operation tips.................................................... 6
8.5 Cutting tips........................................................ 6
8.6 Adjust the length of the cutting line.................. 6
8.7 Adjust the length of the cutting line
manually............................................................ 6
8.8 Line cut-off blade.............................................. 6
9 Maintenance.......................................6
9.1 General information...........................................6
9.2 Clean the machine............................................. 7
9.3 Replace the spool...............................................7
9.4 Replace the cutting line..................................... 7
10 Transportation and storage.............. 7
10.1 Move the machine............................................. 7
10.2 Store the machine.............................................. 7
11 Troubleshooting.................................7
12 Technical data....................................8
13 Warranty............................................ 9
1
English
EN