2. Remove the spool cover (2) and the spool (4).
3. Remove the coil protection (3) from the spool.
4. Remove any remaining line.
5. Install the cutting line or replace with a new spool.
6. Install the coil protection on the spool.
7. Extend the cutting line approximately 15 cm from the
slots (6) of the coil protection.
8. Put the spring in the spool housing (5).
9. Put the spool in the spool housing.
10. Put the ends of the cutting lines through the holes (7).
11. Install the spool cover onto the trimmer head.
12. Push the spool cover until it clicks into position.
11
English
EN
To Next Page
Loading...
