GreenWorks STF311 - Install the Battery Pack; Remove the Battery Pack; Operation; Start the Machine

8.6 INSTALL THE BATTERY PACK
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
• The battery is shipped at 30% charge. Charge the
battery fully before first use.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.7 REMOVE THE BATTERY PACK
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
9 OPERATION
IMPORTANT
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
WARNING
Be careful when you operate the machine.
9.1 START THE MACHINE
1. Pull back on the lock-out button (2) and pull the trigger
(1).
9.2 STOP THE MACHINE
1. Release the trigger to stop the machine.
9.3 ADJUST THE LENGTH OF THE
SHAFT
NOTE
You can adjust the length of the shaft to operate the
machine easily.
1. Stop the machine.
2. Loosen the telescoping boom coupler (1) and move the
shaft to the desired position.
3. Tighten the coupler.
9.4 CHANGE TO THE EDGING MODE
NOTE
The machine can be used in combination with the edge
guide for edging sidewalks and walkways.
8
English
EN