Greyhound 97079 - Engine Oil Level Check; Pre-Start Oil Inspection; Oil Level Verification; Starting the Engine

Page 10SKU 97079 For technical questions, please call 1-800-444-3353.
Starting the Engine
Inspect engine and equipment
looking for damaged, loose,
and missing parts before
set up and starting. If any
problems are found, do not use
equipment until xed properly.
Checking Engine Oil Level
CAUTION! Your Warranty is VOID if the
engine’s crankcase is not properly
lled with oil before each use. Before
each use, check the oil level. Do not
run the engine with low or no engine
oil. Running the engine with no or
low engine oil WILL permanently
damage the engine.
Remove the dipstick and wipe it off 1.
with a clean rag.
(See Figure G.)
FIGURE G
DIPSTICK (121)
2. Reinsert the dipstick completely and
remove it to check the oil level. The
oil level should be between the high
and low marks on the Dipstick (121).
(See Figure G.)
If the oil level is below the low mark, 3.
add the appropriate type of oil until
the oil level is between the high and
low marks.
IGNITION
SWITCH
(145)
12 VDC
CIRCUIT
BREAKER
120 VAC
CIRCUIT
BREAKER
12 VDC
OUTLET
(143)
120 VAC
OUTLETS
(141)
EARTH
TERMINAL
SET
(142)
FIGURE F
FIGURE E
PULLING HANDLE (174)