To Next PageTo Next PageHow to fix MCB error on Grifco C10A?
If your Grifco Controller displays an MCB error due to an internal error, power it off and then back on. If the error is un-resettable, you may need to replace the MCB.
General| Brand | Grifco |
|---|---|
| Model | C10A |
| Category | Controller |
| Language | English |
Explains warning symbols and signal words used in the manual.
Lists critical instructions for safe installation and operation.
Step-by-step guide for connecting the controller and cable through conduit.
Verifies power and correct door movement upon initial setup.
Procedure to reverse the door's open/close movement direction.
Defines the fully open and closed positions for the door.
Enables AUTO mode by removing the R9 Auto Bridge resistor.
Pairing new wireless accessories and erasing existing ones.
Correlates status indicator flashes/lights to problems and solutions.
