To Next PageTo Next PageHow to troubleshoot Grifco ML6102 Door Opening System when no lights are displayed?
If there are no lights on the MCB or Controller, check the transformer and power supply wiring to ensure they are correctly connected. If there is a light on at the MCB but not on the Controller, there may be a bad connection to the Controller.
What to do if Grifco Door Opening System shows that Entrapment Protection Device is removed?
If the opener has detected removal of an Entrapment Protection Device, set DIP 1 to OFF and press the ‘reset’ (RST) button on the MCB for 10 seconds. Relearn any remaining Entrapment Protection Devices.
Why is my Grifco ML6102 Door Opening System showing an under speed error?
An under speed error can be caused by extreme load on the door. Check for objects causing interference to door operation, inspect the door installation, and check for damage to the motor. Consider upgrading to a larger opener if necessary.
Why is the Grifco ML6102 push button not responding?
A non-responsive push button can be due to several reasons: * Check that the RJ45 plugs are securely clipped in at both the Controller and MCB. * Inspect the Controller cable for damage and check connections. * If the Controller buttons are forced and dislodged from the rear of the lid, replace the Controller cable or the Controller.
What causes clutch slip in Grifco Door Opening System?
Clutch slip can be caused by a clutch adjustment set too low, a stalled motor (check the door for mechanical failure or motor fault), or extreme vibration or impact during transit. In the case of extreme vibration, replace the MCB.
What does APE error mean on my Grifco Door Opening System?
An APE error can be caused by an APE position jump or issues with the APE cable (disconnection or fault) or severe close range frequency. To resolve, press the ‘reset’ (RST) button on the MCB for 3 seconds, reconnect the APE cable, or replace the APE cable or APE assembly.
What to do if power light is on but Grifco ML6102 door won't go down?
If the green status light is flashing 2 times, check for obstructions or IR beam misalignment. If it flashes 3 times, check for persistent IR beam obstruction, misalignment or bump edge wiring problem.
Why does my Grifco ML6102 Door Opening System activate from the controller but not the remotes?
If the limits are set, change the remote battery. If using an Expansion board, check the key switch position is in auto and check the MCB and Expansion board DIP switches are set correctly. Also, check that the remote is learned and the receiver card is picking up the signal. If limits are not set, set the limits.
What does MCB error mean on Grifco ML6102 Door Opening System?
An MCB error indicates an internal error. Power the system off, and then on again. If the error persists and is un-resettable, replace the MCB.
What does Safety Input Error mean for Grifco ML6102?
A Safety Input Error indicates that the safety input has triggered. Assess the device connected to the Safety Input.
General| Brand | Grifco |
|---|---|
| Model | ML6102 |
| Category | Door Opening System |
| Language | English |
Covers hazards related to mechanical operation and installation of the opener.
Addresses risks of electric shock and proper electrical installation practices.
Details the numbered components and their functions on the main control board.
Explains the process and considerations for physically mounting the opener unit.
Outlines different wiring configurations and electrical safety requirements for connecting power.
Step-by-step guide to setting the door's fully open and closed positions.
Explains how DIP switches control latching, inching, and myQ operation modes.
Details options, setup, and erasure of safety devices like IR beams and bump edges.
Guides on programming remote controls, keypads, and the myQ Gateway to the opener.
Interprets green light flash patterns to diagnose specific operational problems and their causes.
