Griffon Telephonics RDR-1700A - Page 79

Telephonics Corporation
R ADAR SYSTEMS D IVISION
TM113806 (3/10) 2-25/2-26 blank
Aircraft
P1001
DA-1503B
P2001
RT-1501A
P3001
IN-1502R
NOTE 2
P3002P3004
IN-1702A
P3005P3006P5001P5002
IU-1507B
P5003P5004
112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127
TGT MKR 429 A AHRS 429 B FMS 429 A FMS 429 B AHRS 429 A TGT MKR 429 B
2321
1 2
38 40
SHIELD SHIELD TKR 429 A TKR 429 B
4 5 3
1
2 3
PROGRAM PIN 1 PROGRAM PIN 2 SPARE SHIELD SHIELD
NOTES:
1. MINIMUM WIRE SIZE SHALL BE 22 AWG UNLESS OTHERWISE
SPECIFIED
2. FUNCTION WIRE NUMBERS ARE FOR REFERENCE ONLY
3. WHERE SHIELDED WIRES FROM MORE THAN ONE UNIT
CONNECT AT A JUNCTION STRAP. THE SHIELDS MUST BE MADE
CONTINUOUS BY USE OF A JUMPER OR USE AN EXTRA
JUNCTION STRIP TERMINAL TO CONNECT SHIELDS. SHIELDS
SHOULD BE GROUNDED AT ONE POINT ONLY.
4. COAX EQUIVALENT TO RG-316/U MAY BE SUBSTITUTED
5. ALL LOWER CASE NUMBERS ARE DEFINED BY UNDERSCORE
6. COAX EQUIVALENT TO RG-179/U MAY BE SUBSTITUTED
7.
SHIELDED TWISTED DOUBLE CONDUCTOR
SHIELDED TWISTED TRIPLE CONDUCTOR
8. USE COAX “T” TO SPLIT THE VIDEO IF TWO PORTS FROM THE
FLIR SYSTEM IS NOT AVAILABLE
9. AIR DATA SYSTEM IS NOT REQUIRED IF BARO ALTITUDE
(LABEL 204) IS PRESENT ON THE FMS BUS AND VERTICAL
VELOCITY (LABEL 365) ARE PRESENT ON THE AHRS BUS.
10. CONNECT THESE SHIELD GROUNDS TO CONNECTOR
BACKSHELL GROUND.
RDR-1700A System Wiring Diagram
364-0000-002 Configuration
Telephonics
Date: 30 April 2007 Rev: G Page 4 of 4
Part Number: WD 364-0000-002
128 129
13 14
ADS 429 B ADS 429 A SHIELD
NOTE 9
Figure 2.4.1-9 RDR-1700A
Radar System Inter-wiring Diagram
(Page 4 of 4)
The document reference is online, please check the correspondence between the online documentation and the printed version.