28
USING THE SIDE BURNER
WARNING: IMPORTANT!
USING THE SIDE BURNER
Inspect the gas supply hose prior to turning the gas
“ON”. If there is evidence of cuts, wear or abrasion,
it must be replaced prior to use. Do not use the side
burner if the odor of gas is present.
WARNING: Always keep your face and body as far
away from the burner as possible when lighting.
LIGHT THE SIDE BURNER:
1. Read instructions before lighting.
2. Open lid during lighting.
3. Ensure the knob is in “off” position.
5. Push and turn control knob counter-clockwise to
“MAX” position until click is heard and burner is
lit. then release knob. adjust the flame by turning
control knob between “MAX” and “MIN” positions.
NOTE: If the side burner igniter is not functioning,
see the following section for match lighting.
MATCH LIGHTING THE SIDE BURNER
1. Open the lid to the side burner before lighting.
2. Turn the burner control knob to "OFF".
3. Strike and carefully place a match approximately 1/2"
(1 to 2 cm) from the burner.
4. Turn the side burner control knob to the "MAX"
position. The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to
"OFF" and wait 5 minutes for gas to dissipate and
repeat lighting procedure.
6. If the burner does not light within the first few attempts
of match lighting, there is a problem with the gas
supply. Turn off the gas at the burner and cylinder. DO
NOT attempt to operate the grill until the problem is
found and corrected. See "Trouble Shooting" section of
this manual on page 31.
4. Turn on the cylinder valve.
To Next Page
Loading...