Grillo CL 75 - Page 14

CL75/ Translation of the original instructions
TRACTION RELEASE LEVER
The traction release device is located at the back of the machine under the rear frame (fig. 1, no. 16); if
the machine breaks down, to allow it to be towed or moved by hand, move the lever to idle position. In
the internal position the machine is in neutral position.
MAINTENANCE SUMMARY TABLE
PROCEDURE AT
EACH
USE
AFTER
20
HOURS
EVERY 50
HOURS
EVERY
100
HOURS
EVERY 200
HOURS
Engine oil
check the level ●
change ● ●
Air filter
check ●
replace ٭
Spark plug
check/adjust ●
replace ●
P.T.O belt
check tension ● ●
replace ٭
Check that:
-engine intake grid is clean
-hydraulic engine cooling fins are clean
●
Hydrostatic
transmission
oil
check the level
●
replace ●
(first time
only)
●
Check that blades are well-sharpened and
well-fixed
● ●
Lubricate with grease
● ●
● recommended procedure
٭ procedure to be carried out if necessary
12