Climber 8.22/ Translation of the original instructions
HYDROSTATIC RIDE-ON BRUSH CUTTER
CLIMBER 8.22
Dear Customer,
Thank you for choosing the Grillo CLIMBER. We hope that this new ride-on brush cutter mower will
perfectly meet your requirements. For best use and maintenance over time, please carefully read and
follow the instructions given in this manual. This will enable you to get top results from your mower
and will prevent avoidable expense. Please look after this manual which should always be kept with
the machine.
GENERAL DESCRIPTION AND INTENDED USE
The Grillo machine Climber 8.22 is a ride-on brush cutter designed for the cut of grass, on slopes
also.
WARNING! Before starting the engine, read this manual carefully. The
following warnings are very important in ensuring safety!
WARNINGS
Caution is the best tool for accident prevention. You are urged to read the following instructions for
use of the mower before starting work. Incorrect use of the mower and its equipment may cause
damage. To reduce this risk, follow the precautions given below:
1) Read the whole of this before turning on and using the brush cutter, before starting any work at
all.
2) Pay particular attention to the warnings and safety labels set out around the brush cutter.
3) Before allowing others to use the mower, inform them of the safety rules and carefully instruct
them on how to use the machine.
4) Before starting work, put on suitable working clothes, gloves, boots and protective glasses.
5) Wear special acoustic protections (ear-caps) during work.
6) Before turning on the machine, make sure there are no persons around it; especially children.
7) Before driving the machine in reverse, make sure there are no persons or obstacle in the way.
8) Check the condition of the ground before mowing. Make sure that there are no stones, sticks, or
other objects, which could be run over and become a danger when projected.
9) If any impact with a foreign object occurs, disengage the blade, turn off the engine, remove the
ignition key and examine the brush cutter. If the machine vibrates, have it repaired.
10) Before getting off the brush cutter, turn off the engine, turn off the PTO, remove the ignition key
and lower the cutting deck in the lowest position.
11) Always drive slowly along uneven paths.
12) Keep the speed down when driving down slopes.
13) Always turn slowly when driving downhill.
14) The user is always liable for any damage caused to third parties.
15) Deformed or damaged blades must always be replaced, never just repaired.
16) Always use original GRILLO spare parts and accessories.
17) Only work in sunlight or under effective artificial lighting.
18) Only store fuel in suitable containers designed for the purpose.
19) Be very careful when working close to a road.
20) Allow the engine to cool before putting the machine away in a closed environment.
21) Do not operate the machine when tired or after drinking alcohol.
22) Do not allow any fuel spillage and after filling the tank wipe away any spilled fuel before starting
the engine.
23) Do not tamper with the safety devices or disable them.
24) Do not change the engine settings, especially the maximum r.p.m.
25) Do not rest heavy loads on the seat, the starter safety device could become disengaged.
26) Never attempt any adjustments or cleaning with the engine running.
27) Never allow anyone to check the machine while you are seated at the controls with the engine
running.
To Next Page
Loading...
