Climber 8.22/ Translation of the original instructions
- the belt tensioner bushing engine - cutting plate and the lever articulation using the grease gun
(fig.29).
- the blade shaft bearings using the grease gun (fig.30).
LUBRICATION POINTS
MAINTENANCE SUMMARY TABLE
PROCEDURE EVERY 8
HOURS
AFTER
20
HOURS
EVERY
50
HOURS
EVERY
100
HOURS
EVERY 200
HOURS
Engine oil
check the level ●
change ● ●
Air filter check ●
replace ٭
Spark plug
check/adjust ●
replace ●
Check that the engine intake grid is
clean
●
Check that the hydraulic engine
coiling fins are clean
●
Hydrostatic
axle oil
check the level
● ●
replace
● ●
Check that blades are well-
sharpened and well-fixed
●
Lubricate with grease
● ●
● recommended procedure
٭ procedure to be carried out if necessary