TROUBLESHOOTING
FASTENER DRIVING PROBLEMS
PROBLEM CORRECTIVE ACTION
Tool operates, but no fastener
is driven.
Check magazine for jammed fastener.
Clear jam and reload magazine. Check nail
strip for smooth feeding in magazine.
Tool won't operate - nail jammed
in tool nose, preventing tool
from operating.
Remove jammed fastener. Check
magazine for incorrect, bent, or loose
fasteners, and discard. Reload using
Grip-Rite
®
nails.
Tool leaks air.
Check for source of leak, and tighten
fittings and screws as required.
Discontinue using tool if air leaks at trigger
area or from cap exhaust. Contact your
dealer.
TOOL CHECKS
Keep your nailer in top working condition by checking it daily. See your Grip-Rite
®
dealer
for service if part or operating problems are found. Never use a malfunctioning tool -
it could result in serious injury.
Workpiece Contact & Trigger
Check workpiece contact for proper operation before each use. Workpiece contact
must move freely and return to extended position when lifted from workpiece.
Trigger must operate freely.
Daily Inspection
• Check for broken, damaged, or excessively worn parts, and repair or
replace as needed.
• Check for air leaks at trigger, cap, and nose. Disconnect tool from air supply
immediately if leaks are present, and see dealer for service.
• Make sure all screws are tightened securely.
17
To Next Page
Loading...