5.
Note: A good way to know when they are
touching is to rock the sanding drum back
and forth while raising the table until you hear
or feel contact with the gauge blocks.
6.
7.
8. Step 7
To adjust the sanding drum perpendicular to
the feed direction:
1.
2.
Figure 33
Figure 33.
3.
Note: After you have adjusted the drum, do
not forget to tighten the lock nuts and recheck
the alignment by repeating Steps 1–3.
4.
Figure 32
Figure 32.
To adjust the pillow block bearings:
1. Figure 31
2.
Figure
31
Note: Turn all setscrew sets an equal
amount.
3.
Steps
1–8
Do not over tighten the
lock nuts. The pillow block bearings can
break if over tightened.
To Next Page
Loading...
