-32- G5959/G9957 12" Table Saw
SECTION 7: MAINTENANCE
V-Belt
To ensure optimum power transmission from the
motor to the blade, the V-belts must be in good
condition and operate under proper tension.
When replacing V-belts, it is important to replace
all four at the same time - even if they do not all
appear worn.
Belt tension should be checked at least every 3
months; more often if using the table saw inten-
sively.
The V-belts are accessed through the cavity on
the right side of the saw. They link the arbor and
motor pulleys. To check V-belt tension:
1. Squeeze the center of each V-belt.
2. Note the amount of deflection. Deflection
should be approximately
3
⁄4
" as shown in
Figure 42.
Figure 42. Proper amount of V-belt deflection.
Table
Regular periodic maintenance on your Model
G5959/9957 will ensure its optimum performance.
Make a habit of inspecting your machine each
time you use it. Check for the following conditions
and repair or replace when necessary:
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Damaged V-belt.
5. Any other condition that could hamper the
safe operation of this machine.
6. Inspect blades for damage.
7. Guard alignment and operation.
General
Disconnect power to the
machine when perform-
ing any maintenance or
repairs. Failure to do this
may result in serious
personal injury.
3
⁄4"
Table can be kept rust-free with regular applica-
tions of products like Boeshield
®
T-9. For long
term storage you may want to consider products
like Kleen Bore's Rust Guardit™.
To Next Page
