OM-CC-E and C/2-E
11
Examples: 2 minutes = 00:02
(Just press 2).
1 hour and 30 minutes = 01:30
(Press 1, 3, and 0, or press 9,0
the timer will change to 1:30)
The colon [:] between the numbers on the time
display will blink and the generator will begin to
produce steam. The time will not count down
unless the READY light is lit.
NOTE: You cannot change modes if the timer is
running.
8. To Test Combo Mode Operation, turn on the
power and clear any time from the timer display.
Press the COMBO touch pad. Set the COOK
temperature to 300
o
F (150
o
C). The WAIT light
will come on. It will remain on while (1) the steam
generator fills with water and heats it to its
standby temperature and (2) the air heater raises
the air temperature to 300
o
F. Both actions should
be completed in about five minutes, starting with a
cold unit. When the set temperature is attained,
the WAIT light will go off, and the READY light
will come on.
NOTE: The timer does not control the oven in
either the Combo or Oven Modes.
9. To Test Oven Mode Operation, turn on the
power and clear the Time/Status display. Press
the OVEN touch pad. Set the cook temperature
to 350
o
F (175
o
C). The WAIT light will come on.
Within six minutes from a cold start, the WAIT
light should go out and the READY light should
come on. When that happens, turn the COOK
temperature setting down to 320
o
F (160
o
C). The
HOT light will come on. The heat-up times
provided above may vary slightly as a result of
voltage or water pressure differences.
10. To shut down the unit, switch off the power.
11. If your Convection Combo™ behaves as
described, the unit is functioning correctly, and is
ready for use.