Groen CONVECTION COMBO OM-CC-G Series User Manual

OM-CC-G
21
The de-liming port is on the top of some units.
Cooking Chamber with Partitions in Place
Cooking Chamber with Partitions Removed
On most, it’s directly below the control panel.
it also to the rear of each removable partition.
3) Return the four partitions to their proper
locations in the following order:
Top
— The top partition is flat and has no
holes. Install it by pushing upward, then
pushing from right to left to engage the four
hooks to their support posts.
Bottom
— The bottom partition has a small
circular pattern of drain holes. Place it
directly down onto the four support posts.
Right
— The right partition includes a large,
circular, flared opening that must be
centered in front of the fan. Push downward
to engage the four hooks to their support
posts. If absolutely necessary, you may
remove the wire rack support.
Left
— The left partition includes a back
plate and an air distribution baffle. Push
down to engage the four hooks to their
support posts. If absolutely necessary, you may
disassemble the back plate, baffle and wire rack
support.
Apply oven cleaner to the interior faces of
the four partitions and to the inner door
panel. If you wish, you may also apply it to
the pan racks. Put them back in the oven.
d. Step 4 — De-Liming
Water hardness affects the de-limer’s
performance. In very hard water, stronger
solutions and more frequent applications of
de-limer may be necessary. (Refer to Water
Conditioning on Page 5).
Depending on the date your unit was
manufactured, the de-liming port may be
located at the rear left corner of the top
surface or on the front of the unit support
stand, directly beneath the control panel.

Groen CONVECTION COMBO OM-CC-G Series Specifications

General

Brand	Groen
Model	CONVECTION COMBO OM-CC-G Series
Category	Oven
Language	English