Grouw! 17940 User Manual

41
GB
Changing the PIN code
1. Switch the robot lawnmower on as described above
so that the on/locked indicator light (j) lights up
green.
2. Press the LOCK/4 (e) and OK (f) buttons at the same
time. The on/locked indicator light ashes green and
red.
3. Enter a new 4-digit PIN code using the 1-4 buttons (b,
c, d, e) and then press the OK button. The on/locked
indicator light ashes green.
4. Enter the same PIN code again and press the OK
button. The on/locked indicator light lights up green.
The PIN code has now been changed.
5. Keep in mind that the PIN code is an eective anti-
theft measure! If you forget your PIN code, you
cannot unlock the control panel or use the robot
lawnmower!
If you forget your PIN code, you must visit www.schou.
com and follow the instructions on obtaining a new
PIN code. For this, you will need the robot lawnmower’s
serial number and the purchase receipt.
Updating the rmware
Note!
• Therobotlawnmowermustbepositionedwithinits
working area once the update is complete.
• Thermwareupdatemustbeperformedwithafully
charged battery.
• Donottouchthemainswitchduringthermware
update.
1. Download the rmware update from www.grouw.
dk or www.schou.com. You can also read the update
instructions there. Copy the rmware update onto an
empty USB stick (max. 4 GB, not supplied), which is
FAT32 formatted. Double-click on start.bat to extract
the rmware les.
2. Set the main switch (5) to the OFF position. Open the
battery cover (7) and remove the battery.
3. Insert the USB stick into the USB jack as illustrated.
4. Re-insert the battery and set the main switch (5)
to the ON position. Press the POWER (a) and OK
(f) buttons at the same time for 5 seconds. All the
indicator lights light up green.
5. Press the LOCK/4 button (e). The rmware update
starts. When all ve indicator lights for work time (i)
are lit, the update is complete.
The update typically takes 3-5 minutes. If the update
has not started after 1 minute, this is due to incorrect
use or because the USB stick is damaged. Try using a
dierent USB stick.
6. Remove the USB stick and replace the battery cover.
Rain sensor
The robot lawnmower is equipped with a rain sensor so
that it can detect when it rains. The robot lawnmower
is programmed at the factory to return to the charging
station when it is raining suciently to activate the
rain sensor. There it will fully charge and then wait until
the rain sensor is dry before automatically starting to
cut the grass. If this start time is outside of the robot
lawnmower’s daily work time, it will not start again until
the following working day.
Note!
Do not short-circuit the rain sensor!
Note!
The robot lawnmower must return to the charging
station and the charging station must be disconnected
from the mains during a thunderstorm. Damage caused
by lightning strike is not covered by the guarantee.

Grouw! 17940 Specifications

General

Brand	Grouw!
Model	17940
Category	Lawn Mower
Language	English