Setting inverter’s COM address
When communicating with monitoring software or device, the software or device
may regard inverter’s COM address as communication address (Also may use
inverter’s serial number as communication address).The COM address could be
assigned. The second level menu “Set COM Addr” of setting is to set inverter’s COM
address.
Setting steps:
Input password->Setting->Set COM addr->Set Manual, “Current Addr” is the
current address of inverter.”COM Addr Up”add address. ”COM Addr Up” decrease
address .Single knock to change value of fixed address, double knock enter next
manual. Choose “YES”to save changes, and LCD screen will display “Set Addr OK!
Current Addr XXX”, see Fig 6.3.19 for reference.
Setting language
To change inverter’s displaying language, please select Setting->Set language, then
LCD screen will display current language type, single knock to change current
language, double knock will save changes and displays “Set Language OK! Current
Language English” see Fig 6.3.19 for reference.
Please note in order to prevent disoperation, system language won’t be change in
second level menu “Set language”, but it will be only if user saves save the choice by
double knock and LCD displays “Set OK!”
The inverter provides five languages: Italian, English, German, Spanish, and French.
The number on Set language interface is sequence number of these five languages,
the sequence number and its corresponding language are shown in Table6.5.
Table6.5 sequence number of languages
Language
Sequence Number
Italian
English
German
Spanish
French
0
1
2
3
4
Setting inverter time
Inverter provides a system clock; user must set the system time after installation, as
the historical statistic data for a period were based on the clock. User can set the
following time parameters: year, month, day, hour, minute. Refer to Fig 6.3.19.
Set year: Setting->Set time->Set year->Year up or Year down->knock to change year.
Thrice knock to exit and save changes.
Set month: Setting->Set time->Set month->Month up or Month down->knock to
change month. Thrice knock to exit and save changes.
Set date: Setting->Set time->Set date->Date up or Date down->knock to change
date. Thrice knock to exit and save changes.
Set hour: Setting->Set time->Set hour->Hour up or Hour down->knock to change
Hour. Thrice knock to exit and save changes.
Set minute: Setting->Set time->Set minute->minute up or minute down->knock to
change minute. Thrice knock to exit and save changes.
5.8. Special connecting
6.4.1 Graphic display
45
46
To Next Page
Loading...
