3. Make the cable through the hole of cable gland and put the cable into the RS485 terminals,
fix all cables with screwdriver (‘1’to’ T/R-(RS485B)’, ‘3’to’ T/R+( RS485A)’, ‘2’ to the
shielding layer or no connection). The type of cable is recommended as STP, FTP,ASTP.
4. Plug in two terminals. Cover the fix board.
5. Tighten 4pcs screws and cable gland.
Pull cables outwards to confirm whether they are installed firmly
Tighten 4 pcs screws first, then tighten cable gland.
To Next Page
Loading...
