17
18
6.4 Connecting signal line
The MID series inverter has an 8Pins signal connector, and the client signal line port is as
follows:
fig6.7 Quick installation instructions
1.Strip the cable 10mm through the waterproof gland, thread the sleeve, and tighten the
screws. Make sure the cable is well connected.
fig6.8 Quick installation instructions
2.Push the threaded sleeve into the socket and tighten the waterproof gland.
fig6.9 Quick installation instructions
Ka
3.Dock the client to the inverter plug until both are tightly locked to the inverter.
The inverter side
Ka
fig6.10 Quick installation instructions
Disassemble the signal connector
1.Press the fastener and pull it out of the inverter.
fig6.11 Quick installation instructions
The inverter side
2.Insert the H-tool and pull it out of the socket.
fig6.12 Quick installation instructions
To Next Page
Loading...
