37
38
6.4.4 Work mode set up
•”
•Workmode depend on the situation. If SPA is in normal state, it will show ”normal”. If
SPA is standby state, it will show as “standby” etc.
•Some special definitions are explained, for example: Vb means the voltage of battery.
Cb means the capacity of lithium battery (only lithium battery show this data). Pm means
the monitor power of user.
Down” control command (if pushing “up” button, command will go back).
NOTICE:
Some special definitions:
Parameter:Description
Vb:Battery voltage
Cb:Battery capacity (only for lithium battery)
Pm:Power monitoring (from grid is positive, to grid is negative )
Keep pressing “enter ”for 3S， you can enter set up surface， in the set up surface you
need hold button.
Enter or ESC 1S for selection, you can see the surface as showing below.
Fig 6.13
If you choose CEI and used SPA inverter in Italy, SPA inverter have Auto Test function.
How to use the Auto test function. Please see the annex.
•Under the Basic Para ,you can see the setup options below after pressing Enter for 1S：
Fig 6.14
Fig 6.15
In the basic Parameter， you can set language （English， Italian ,German） ， system
time , lead-acid cell charging voltage (default is 58V)， discharge low voltage (default is
48V)and lead-acid constant current (default is 60A).
Under the Back Up ,you can see the setup options below after pressing Enter for 1S：
In the back up you can set EPS ,including enable or disable (default is enable ),AC
voltage(default is 230V) and frequency(default site 50HZ).
Under the Priority ,you can see the setup options below after pressing Enter：
To Next Page
Loading...
