NOTES
If you exit Emulation Station and don't have a keyboard to
return, press the joystick up once or until either
"emulationstation" (Pi 3) or "arcade" (Pi 4) appears and
then press rear button 1. The joystick is used to scroll
through the commands entered in the terminal.
Use the Soft Power button to shut down at any time. If the
power switch is on, this button will also start the system
again. Once the system is shut down and the green Pi
LED is off, slide the power switch to OFF.
All inputs can be customized. If, for example, you want to
play a game that uses a joystick and 2 buttons, while in the
game, hold Joystick Down + Coin 2 until the MAME
configuration menu appears. Choose Input (this game) or
Input (general) if you want to change for all games. Use
the joystick to navigate to the control you want to edit, then
press A followed by the control you want to use. P1 Button
1 set to '2 RetroPad1 B' (center button), P1 Button 2 set to
'LCTRL RetroPad1 A (right button), and 2 Player Start set
to 'ESC' (rear btn 2) is a good choice. After all changes
have been made, press the B button until you are back at
the game.
RetroPie inputs can be configured under Configure Input in
the Main Menu (press Start from the main screen). Press
the control you want to use for each input. Hold any button
to skip an input. For Hotkey, Coin 1 (or whatever you
choose for select) is recommended.
If you want to change the keyboard mappings, this is done
by editing the file /boot/retrogame.config. For more
information, see https://learn.adafruit.com/retro-gaming-
with-raspberry-pi/configuring-retrogame.
To Next Page
Loading...