Grundfos CIU 200 - System Description; Modbus; CIM 200 Modbus RTU; CIM 260 3 G;4 G Cellular Modbus

3. System description
3.1 Modbus
The system diagrams provide an overview of the different
technologies and how to connect the module or unit to the Grundfos
E pump that you connect to a Modbus network.
CIM solution
The Communication Interface Module (CIM) is an add-on
communication module you install internally in a Grundfos
E-pump using a 10-pin connection. In this setup, the E-pump will
supply power to CIM 200.
For mounting of the CIM add-on module, see the installation and
operating instructions for the E-pump in question.
CIU solution
The Communication Interface Unit (CIU) is a box with a power
supply module and a CIM Modbus module. You can mount either on
a DIN rail or on a wall.
You use it in conjunction with Grundfos E-pumps that do not support
an internal, add-on communication module, CIM.
Related information
3.2 CIM 200 Modbus RTU
3.2 CIM 200 Modbus RTU
Modbus RTU
CIM 200
TM080188
Principle sketch of CIM 200 Modbus RTU solution with add-on
CIM module installed inside the pump. The figure shows a
MAGNA3 pump
Modbus RTU
CIU 200
GENlbus
RS-485
TM080189
Principle sketch of CIU 200 Modbus RTU solution. The figure
shows a CUE-drive for pumps
The CIM module or the CIU unit is connected as a Modbus slave
directly to the Modbus network.
3.3
CIM 260 3G/4G cellular Modbus
Cellular
CIM 260
TM080190
Principle sketch of CIM 260 Modbus cellular solution with internal
add-on CIM module and external antenna. The figure shows a
CRE pump
GENlbus
RS-485
CIU 260
Cellular
TM080191
Principle sketch of CIU 260 Modbus cellular solution with external
antenna. The figure shows a CUE-drive for pumps
3.4 CIM 500 Modbus TCP
Modbus TCP
CIM 500
TM080193
Principle sketch of CIM 500 Modbus TCP solution with internal
add-on module. The figure shows a CRE pump
Modbus TCP
CIU 500
GENlbus
RS-485
TM080194
Principle sketch of CIU 500 Modbus TCP solution. The figure
shows a CUE drive for pumps
6
English (GB)