Grundfos CM - Product Handling and Disposal Safety; Liquid Filling and Maintenance Safety; Product Decommissioning and Disposal

English (GB)
6
Electrical connection Liquid filling
Maintaining the product
Fault finding the product
DANGER
Electric shock
Death or serious
personal injury
- Before starting any
work on the product,
make sure that the
power supply has been
switched off and that it
cannot be accidentally
switched on.
- The pump must be
connected to an
external all-pole main
switch according to
local regulations.
- The product must be
earthed and protected
against indirect contact
in accordance with
local regulations.
- Wires connected to
supply terminals, must
be separated from
each other and from
the supply by
reinforced insulation.
CAUTION
Hot or cold liquid
Minor or moderate
personal injury
- Wear personal
protective equipment.
- Pay attention to the
direction of the vent
hole when you fill the
pump with liquid and
vent it.
- Make sure that no
persons are hurt by the
escaping liquid.
DANGER
Electric shock
Death or serious
personal injury
- Before starting any
work on the product,
make sure that the
power supply has been
switched off and that it
cannot be accidentally
switched on.
WARNING
Corrosive liquids
Death or serious
personal injury
- Wear personal
protective equipment.