Need help?Do you have a question about the Grundfos CRNE and is the answer not in the manual?
General| Brand | Grundfos |
|---|---|
| Model | CRNE |
| Category | Water Pump |
| Language | English |
Symbols and hazard statements for safety warnings.
Methods to identify the pump, motor, functional module, and operating panel.
Precautions for installing outdoors or in humid environments.
Securely fastening the pump and positioning the drive unit correctly.
Requirements for protective earth and indirect contact protection.
Residual-current breakers, over/undervoltage protection, overload, and phase unbalance protection.
Steps for installing a communication interface module.
Important safety warnings before starting up the product.
Using Grundfos GO for wireless communication and product control.
Using Grundfos GO Link for wired or wireless communication.
Selection of various control modes for pump operation.
Enabling and setting the FLOWLIMIT function.
Recommended controller settings (Kp, Ti) for various control modes.
Setting operating range and influencing setpoint with external signals.
Monitoring parameters and setting actions when limits are reached.
Using LiqTec sensors and configuring low-flow stop function modes.
Stopping the pump at minimum speed when consumption is low.
Determining pump reaction to alarms and selecting motor bearing monitoring.
Managing service intervals and configuring wired/wireless communication.
Configuring Modbus RTU settings and Ethernet parameters.
Controlling two or more motors in parallel for system operation.
Safety warnings for electric shock, crushing hands, falling objects, and hot surfaces.
To Next Page
